Shoe Goo and Tape: The Method to Make Your Skateboarding Shoes Last (2026)
Do your skateboarding shoes have an ollie hole after two weeks? Welcome to the club. Good news: an €8 tube can give them 6 more months. Here’s the method pros have used since the 90s.
⏱ Reading: 5 min
Why Shoe Goo Saved a Generation of Skaters
In the 90s, buying a new pair of Vans Half Cab or Etnies Lo-Cut every month was impossible. So skaters did what their surf elders did: they got out the glue. Shoe Goo, created in 1972 by Lyman Van Vliet, became the go-to solution for patching the holes grip tape tears through with constant kickflips.
Today, despite Nike SB shoes at €110 and Duracap reinforcements, the problem is the same: the ollie zone gets thrashed. The grip shreds the canvas, the stitching gives out, and one day your foot goes right through. Repairing instead of trashing is also a move that sticks to the original skateboarding philosophy — resourcefulness, economy, longevity.
The Step-by-Step Method in 6 Steps
1. Clean the Area
Brush, warm water, soap. Glue won’t stick to road dust. Dry it well — residual moisture is mistake number one.
2. Trim Any Loose Threads
With a utility knife or fine scissors. You want a smooth surface for the glue layer to adhere evenly.
3. Stuff the Hole from the Inside
Slip a piece of thick fabric (or old denim) inside the shoe, against the hole. This acts as a base so the glue doesn’t sink into your foot.
4. Spread Shoe Goo in a Thick Layer
2 to 3 mm thick. Overlap 1 cm around the hole so the glue grips the intact canvas. Smooth with a wet finger (glue doesn’t stick to water).
5. Let Dry for a Minimum of 24 Hours
Not 4 hours. Not 8 hours. A full 24 hours, in the open air, at room temperature. Skating a repair that’s not dry = losing it in two ollies.
6. Apply a Second Coat if Needed
If the hole is big, a second coat after 24 hours doubles the repair’s lifespan. That’s what Andrew Reynolds has been doing for 25 years on his Emerica shoes.
The 3 Essential Products
The gear to repair for 6 months won’t cost more than €15. That’s less than a fast-food meal. Here’s what really works.
TRANSPARENT SHOE GOO 109 ML
The American original since 1972. Flexible, abrasion-resistant, transparent when dry. One tube lasts for 4 to 5 repairs.
Fast Shipping · 30-Day Returns
BLACK GAFFER TAPE ROLL 50 MM
The secret weapon of old-school skaters: wrap your forefoot with gaffer tape before your session. Protects the canvas and slides perfectly on the grip.
Fast Shipping · 30-Day Returns
SELF-ADHESIVE CANVAS SHOE PATCHES
Pre-cut reinforcements to stick on the ollie zone BEFORE the hole appears. Prevention rather than cure — Lakai’s strategy.
Fast Shipping · 30-Day Returns
Bonus: The Tape-on-Shoes Trick
Before each session, some pros wrap black gaffer tape around the area that rubs the grip. You can see this in Girl’s 2003 film Yeah Right! on Eric Koston‘s feet. Three wraps around the metatarsal, a dab of glue to seal it, and the shoe takes zero damage for 2 hours. Remove it after the session, and you’ll find the canvas intact.
It looks rigged — that’s the point. 90s skateboarding was about making do with what you had, not waiting for the next collab.
Mistakes That Ruin the Repair
| Mistake | Consequence |
|---|---|
| Drying in 4 hours to skate in the evening | The glue cracks on the first ollie |
| Thin layer « to make it neat » | No resistance to grip tape abrasion |
| Super Glue instead of Shoe Goo | Becomes brittle, cracks in 2 days |
| Forgetting the inner fabric plug | Glue drips inside the shoe and creates bumps under your foot |
An €80 pair of Vans Old Skool Pros that lasts 6 months instead of 6 weeks means €320 saved per year. With that, you can buy a new deck and a hoodie. That’s also what skateboarding is about: a logic of self-sufficiency that’s part of the culture.
